The purchase of disassembled components to create a new suction system is now very common especially for systems simple to install. Fundamental support in the design phase of our technical office and the care in packaging with labelling and numbering service.
To equip your company with a new suction system it is not always necessary to rely on a plant engineer who provides the turnkey service, but there is finally an alternative: purchase the various components of the suction system disassembled and prepared for mechanical installation. Thanks to the design support of our technical office, the assembly will be simple, with a significant reduction in the total costs of the system and greater flexibility of work since it will be possible to organize the activities independently.
The plants that can be built independently are normally those intended for the extraction of fumes, dust, and exhalations and therefore do not require heat treatment of the air, for example for welding fumes, grinding powders, sanding or the exhalations of painting and retouching.
Most of the systems are always composed of 3-4 fundamental components, let’s see what they are:
This is the first fundamental component from which to design a fume, dust, or other exhalation suction systems.
It is usually recommended to aspirate the pollutants as close as possible to the emission source, so the suction arms are widely used, but in some cases the hoods are also an excellent solution as the suction benches. All these systems are prepared with the necessary fittings for fastening and then be connected to the suction pipe. |
![]() |
System component very simple but at the same time difficult to design correctly, the connecting pipes for suction systems between the collection systems and the suction unit must be dimensioned according to very precise parameters that vary according to the type of pollutant aspirated and the air flow.
The channels and pipes proposed by us are usually circular section, made of galvanized steel sheet (Z275) with thicknesses, tolerances, and construction characteristics in compliance with the standards UNI EN 10142, UNI EN 10143, Eurovent 2/3 and UNI EN 1506. They are designed with variable section to maintain balance and constant speed in the circuit. Normally there is a main manifold to connect the suction points to the fan or filter and then to the exhaust chimney. Included are the galvanized sheet infill for crossing manufactured output, special connectors and stirrups made to measure. |
![]() |
The centrifugal fan is sized according to:
It is positioned on the ground or on the wall, depending on the path of the pipes in the suction system. In all cases for a correct installation , specially designed components are required for these uses. |
![]() |
Depending on the type of pollutant aspirated, the concentrations present in the company, local regulations for emissions into the atmosphere is usually necessary to insert a filtration system before the chimney or the exhaust fan.
The filters are designed after analyzing the parameters of the intake system, normally for plants not too complex are divided into these types
|
![]() |
Last component not to underestimate is the electrical panel in service of the suction system which can be:
In these cases, in fact, it is possible to guarantee significant energy savings, for example:
|
![]() |
Once our technical consultants have received the necessary information to size the plant, they produce a complete offer of all the necessary components, within which pre- and post-sales assistance is always included.
All the components of the plant supplied are complete with CE certifications, manual maintenance and when necessary or required of the numbered installation diagram in order to avoid errors during the assembly phase.
|
![]() |
Our technical department is available for further clarification, simply fill in the form at the bottom of the page to be contacted by a specialist.
Fill in the form below to request a quote by email, agree on special conditions, or technical clarifications